How can I get a PIC to switch 2.5V DC to my Opamp pin?

[HankMcSpank]

So I found this little circuit that works well for my needs - the circuit takes one small analogue signal into an opamp & when a SPST switch is flicked, the opamp output changes from non-inverting to inverting.



I've changed the circuit to illustrate my needs - it normally switches a ground to the non inverting pin - that's fine if you're using dual rail/supply opamp circuits - but all my circuit is single rail & therefore my opamp pins input pins aren't biased at ground potential ..........my circuit uses a single rail of 5V - therefore all my opamps are biased at VCC/2 .... 2.5V.

So therefore rather than switch a ground to the non inverting pin (which would have been easy to do with a PIC!) ...I'm faced with having to switch 2.5V - so I'm looking for a way to get the PIC to do this with the lowest component count possible! Also, I want to avoid relays as I just don't have the PCB real estate available.

Now Melanie touched upon a way of switching to 5V/0V from a mid 2.5V DC potential (http://www.picbasic.co.uk/forum/showthread.php?t=11163 ) ...but I can't see how I could use her clever little suggestion in this instance - because the cicuit above is an on off switch.

Any ideas?