u means the mode no of"8276" not 9600 baudrate? or the VDIP2 firmware not 9600 baudrate?
u means the mode no of"8276" not 9600 baudrate? or the VDIP2 firmware not 9600 baudrate?
No, I mean what you had was not 9600
And I have no idea what your firmware on the VDIP is.Start:
SEROUT2 VinRXD,84,["ECS",13] '9600 TRUE
HIGH VinRXD
PAUSEUS 10
SEROUT2 VinRXD,84,["IPA",13]
HIGH VinRXD
PAUSEUS 100
SEROUT2 VinRXD,8588,["DIR",13]
GOTO Start
Dave
Always wear safety glasses while programming.
i ready the the firmware...no prob...
did u means change the mode no to 84?
me already change to 84 but...also the same no respond for the hyperterminal...
Sorry, been a long day.
Either 84 or 16468 depending on if the PIC is connected to the VDIP with an inverter chip or not.
Dave
Always wear safety glasses while programming.
the pic didt connect any inverter chip...the pic TX pin connect to the RXD pin of VDIP2 and RX pin connect to the TXD pin of the VDIP2
How is the VDIP connected to hyper-terminal?
Dave
Always wear safety glasses while programming.
using rs232..like the diagram you post before
Last edited by fokus_1116; - 8th March 2010 at 21:03.
Bookmarks