I'm not seeing any today either.
Type: Posts; User: peterdeco1; Keyword(s):
I'm not seeing any today either.
We aren't looking for fencing on an electronics forum.
Thank you Lester. It works now.
The green thumb does not work for me. It says I first have to register. I'm registered and signed in.
I get that same error with my U2 with PIC16F819. The message will either be "Target device does not match specified device", "Configuration verify error at 0000" or "Configuration verify error at...
Google Phillips RC6 protocol. This is one of many that comes up.
http://www.pcbheaven.com/userpages/The_Philips_RC6_Protocol/
I did this a long time ago with a 4X4 membrane switch to play messages on an ISD chip.
Low PORTC.7
Pause 1
IF PORTB.4 = 0 Then MESSAGE1
IF PORTB.2 = 0 Then MESSAGE9
High PORTC.7
Low...
The PIC's that are programming properly are 8 pin 12F629, 12F675 and 12F683. The 28 pin PIC's programming properly are 16F73 and 16F872. It's only the 16F819 that doesn't work.
I recently bought a U2 melabs programmer. It programs 5 different PIC's without a problem. However it will not program a 16F819. All I get is "TARGET DEVICE DOES NOT MATCH SELECTED DEVICE." Any ideas...
I like the way you snuck in that link right after your first word "Well(link).
I am now going through something similar. Out of the blue my PicStart Plus at the office won't program 16LF819. I also have another one there and I get the same error readings. However both program 8...
It seems like this just started recently.
We were doing this with an ISD5008. When that was discontinued we started moving into an ISD4003-08MPY. That was recently discontinued and are moving into an ISD17240. With a 4KHZ sampling frequency...
https://www.findchips.com/search/12f683
Are you using the shiftout command? If so you can select MSB or LSB first.
Are you looking for a particular Microchip part?
I'm sure by "spec's" he means how much current does the relay draw.
I agree Richard. It's like putting a Ferrari engine on a lawnmower. At work we have a small PCB with an 8-pin PIC and 4 of these mosfets. It replaces about a dozen different subassemblies in products...
Yes, although I use a 47K across gate to source. Either way it will work. EDIT Note there is a L in the part number for Logic Level. It is NOT the standard F.
Never tried 2N7000 but for 3V outputs, we use an IRLZ44N. It's a power mosfet that we use to switch up to a couple of amps without needing a heatsink.
You will send 00000011.
I haven't done this in a long time but here is a snippet of code I used to send by SPI to a device:
Low PORTA.3 : Pause 10 'CHIP SELECT
ShiftOut PORTC.5,PORTC.3,0,[9254\16] 'playconfig0
ShiftOut...
It's working for me now.
Well I didn't receive a notification that this thread was replied to. I guess it's still not working.
Yes same problem here. I used to but not anymore.