Search:

thanks guys for all your help. i found my problem(s), simple counting error and typo in the code.

Would you happen to know how the offset works as mentioned in the previous post? I ran in to some problems with that block of code and think it has to do with finding and setting the offsets of the...

thanks for the reply that was exactly what i was looking for. I am basing my code off of this post http://www.picbasic.co.uk/forum/showpost.php?p=22012&postcount=11. thanks again

i'm looking for something closer to what joe s. has so that i can run some code in a loop and have it change if those pins are high or low without having to have a separate if statement for each pin....

Hello,

I'm hoping someone can point me in the right direction, I want to create an array of pins something like what is shown below, but I haven't found a way yet. Thanks in advance guys.


...

I was afraid of it blowing the pic. I wrote one pic off to ESD because I knew I was being careless but didn't think it was ESD, just didn't want to think it got blown when working on it at one...

Hello,

I seem to have hit a issue that I cannot pinpoint. I was not there when it happened and have not looked at it yet but I have been told that a board that mounts on top of a series string of...

well what do you know...it works now. Many thanks. I guess I kinda missed the part about that changing when enabling A/D....oops

Thanks for the reply I will give that a try tomorrow. I am still confused as to why it works in the main program loop that calls that sub show above with out having those set. I will let you know...

Hello all,

Finally have a question that the search hasn't answered for me. I have a pic18f24k20 that reads 8 a/d lines and then based on the values of the a/d lines it controls 8 additional...