thank you all for your help,, here is what i did,
i ran the cpu on lower speed than the 48mhz needed for the USB, which did the trick without the need to switch the clock on the fly.
thanks...
Type: Posts; User: viewgsm; Keyword(s):
thank you all for your help,, here is what i did,
i ran the cpu on lower speed than the 48mhz needed for the USB, which did the trick without the need to switch the clock on the fly.
thanks...
hi all,
I need to change the clock speed on the fly or dinamicly in the code ,
i am using pic18f4550 and i need to switch from 48mhz to 24 or even 4 mhz to drop power consumtion in certin...
Hi all,
what do we need to change and what files in order to make a compsite device
to work with PBP ?
I updated the descriptor file to have 2 interfaces and 2 report files
my device can...
its already attached above ,,
sorry I was wrong , I source above is fine , it was my mistake
I didn't installed borland C++ right ,
everything now is ok , and again , the source code above...
I called the support today !
Ok,
1st : the clock is not getting set right form the config. inside the INC file !
the PLL is not going on unless you turn it on manualy from your...
Ok,
Now I know my hardware is OK !
it works with the mouse demo from Microchip !
so whats wrong with PICBASIC ?!
Thank you
i think I missed to connect VUSB to VDD , so I did , and still no luck !
PBP INC. file
CONFIG XINST = OFF
CONFIG PLLDIV = 1 ' I tested this value with 4Mhz and PLLDIV 5 with 20Mhz
CONFIG WDTPS = 512
CONFIG CPUDIV = OSC1
CONFIG FOSC = HSPLL
...
Hi,
Did anybody got the new family J50 to work with pbp2.5 ?
I can't get it to work !
1st I had problem to fix the clock !
I had to set the OSCTUNE.6=1 to enable the PLL ! and get the 48Mhz !...
still , do u mind sending me the full copy , I will try to test it
Thank you
hi, too many headers ,
if you may send me a full copy , I will post an easy web link .
Thanks
VrBitmapDial.hpp
VrControls.hpp
VrAngularMeter.hpp
VrLabel.hpp
VrLeds.hpp
there are some missing headers
would you please email full copy to me
viewgsm_at_hotmail.com
thank you
Hi
I agree with Acetronics
also this PULL-DOWN will not help if the pin went high for low time ,
this will help to keep your PIN pulled to the ground (NOT FLOOATING) in case the pin was...
Hi,
Just to be sure , use a PULL DOWN resistor (10K is fine ) to the GND
Good luck with ur project , sounds fun
can we use Microchip CDC firmware and change the VID/PID to another one ?
or change the device name ?
Thanks