Hi,
Just wondering if anyone has any experience or thoughts on setting the ID of a PIC by using the ADC and a resistor network, and mapping the value to an ID on startup. I would like to be able...
Type: Posts; User: breesy; Keyword(s):
Hi,
Just wondering if anyone has any experience or thoughts on setting the ID of a PIC by using the ADC and a resistor network, and mapping the value to an ID on startup. I would like to be able...
Im not very familiar with I2C, however I remember seeing this:
http://www.picbasic.co.uk/forum/showthread.php?t=587&highlight=i2cwrite
See the first point, 'Do you have any CONSTANTS in the...
Hi,
I have a little side task that I have been working on, basically its a string of RGB led's strung together to produce a decorative christmas lighting effect.. Each of the LED's is actually a...
Hey,
I've been using pbp pro for a while, however I have for the first time found a need to optimise code within a loop (software PWM) and in doing so have a few questions I was wondering if...
Hi,
Problem solved with addition of 33pF cap between the line and ground..
I am at a loss to explain why... Could there have been a high frequency ripple that I could not see on the scope since...
PIC18F2525 running at 20Mhz with a ceramic resonator.
The Rx line is fed directly from the XBee Tx, Tx (if relevent) goes through a voltage divider to give 3.3v input to the XBee..
...
Hi,
Im having a problem where the usart sucessfully receives characters for a few seconds, each time sending a response, however inevitably stops receiving characters after a while (Interrupt is...
Hmm I tried the changes that bruce recommended and made sure lvp was off, but still not working... I get 'Activated' after everything i send to it (and the LED doesn't turn off)
No luck, still restarts after every HSERIN..
Strange thing is with only a few small modifications the code works on 16F chips.
Also, if i send data with the wrong address byte, ie something...
Hey, im trying to (at first) get some simple RS-232 communications between a computer the pic using the following code:
DEFINE OSC 20
' Setup Hardware for UART
DEFINE HSER_BAUD 9600
DEFINE...
Thanks, that was it.. Its amazing how I could miss it after reading through the code so many times..
One more quick question, is it possible to clear a single line of an lcd display, or atleast...
Hey,
Im having trouble on a PIC16F88, as far as i can tell the code should be outputting the data on all eight pins of PORTB, but pins 4-7 are allways low, see the example below:
DEFINE OSC 8...