Example
http://www.garydion.com/projects/videoverlay/
Can this be done on pic basic pro
thanks
Type: Posts; User: jetpr; Keyword(s):
Example
http://www.garydion.com/projects/videoverlay/
Can this be done on pic basic pro
thanks
Hi All
I need some Help to make a Table to load cake the cake have to be on balance inside a car to move on road.
Any help or Idea is for me wife.
Thanks
thanks
i have to do test
Yes i need that
Hi
i like to make small Tracker body heat with a pic this is posible.
If Any one have don this.
I need some help to get it start on my litter project.
thanks
this one can make the job 18F4550 i have some code done i have to buy the parts and test
Thanks to all input
I going to start as soon as possible i have to buy parts like 32bit pic or 16bit and MPU-6000/6050 Six-Axis (Gyro + Accelerometer)
I going to use external ESC manager with pulseout this way the board is small and easy.
I like to test the Power of PicBasic Pro with this projects is going to be open source for the pic users.
...
Hello
If any one have Made a QuadCopter using PicBasic Pro
i like to made one
thanks for the help
If any one have idea how to use picbasic pro with WIZ811MJ
i need to made i IP/TCP relay on/off or any pic chips i can use to do this
thanks
i need help where to start
:)
'For global reference to system voltage, use the Voltage variable, which is based on a
'scale of 1 to 1000, with 775 = 7.75 volts. Remember that the resistors on the board
'divide the...
i use this and work
DEFINE ADC_BITS 8
DEFINE ADC_CLOCK 3 'Uses internal RC clock
DEFINE ADC_SAMPLEUS 10 'Microsecond sample time
You Can use Hall Sensor
By read of North and South of the magnet it account 1 return for each turn of the shaft.
how i made the picbasic pro to do this
The ESC requires a 50Hz carrier signal between 1 millisecond and 2 milliseconds to operate. 1ms is zero throttle and 2ms is full throttle. You will not need...
no work PULSOUT PORTB.2,255 i use all number from 0 to 1000 and the speed control no start the motor
Thunderbird 18 from castlecreations
Thanks for help
I use LM358 read from 0c to 1000c and thermocouple type k
NumSamples CON 48
'ADCIN EGTChannel, EGTSample '0 to 255 EGT sample
EGT=0
EGTSample=0
For i = 0 TO...
no am using a castle brushless speed contol i need to send pulse to the r/c connector to made run the motor like connect to a r/c radio
i need help how to use brush less speed control with picbasic pro
to run the motor by emulate rc radio.
RPM=0
RPMSamp=0
RPMSamp1=0
RPMSamp2=0
'** RPM **
'60 ms Sample time yields direct RPM readout in 1000's
'Comments start with real RPM of 143,578 and RPMNumSamps=3
Count...
Hello is some one have this problems and fix it help me..
my pic work but when i on plug a hall sensor and my pic freezing ..
:rolleyes:
I have some problems and i think is the Programmer or the configuration of the pic18f2620 i have USB programmer from MeLabs or recommend a good programmer..
Any Help
All time i made change to...