Search:

Richard,

Thanks for the prompt reply.

In some ways it is a relief to know it is not the code. That is a big step forward.

As per my first post I had tried two different programmers, both...

Richard,

Thanks for your comments. We are not all perfect, but I shall try to do better next time re typos. .

I copied by cut and paste then compiled your code exactly as you sent it.

The...

Richard,

Thank you very much for a very helpful reply.

dgg1 was of course a typo - being too clever in the (adjusted) cut & paste process. Ditto for the missing Pause 50. I did intend the...

Addendum to my post with code included. Line 176 should read "PulsePin = 0" A typo in my transferring the code. Sorry.

Analyser shows the clock "ticking" at 1MHz, corresponding to the default 4MHz/4, not the 2MHz I intended to set.

The analyser shows GPIO.5 going Hi and staying there until the power is turned off....

I have been testing a program for a 12F683 to drive an RC servo. The compiler is Picbasic Pro ver 3 and both QL 200 and IDE 2 programmers give the same result. The programmed chip does nothing. ...

I have bee trying to find a way to single step through PicBasic Pro code " on the bench" without connection to any microcontroller. I have not been able to find anthing that does this.

In...