I didn't do that setting before. I did it now and everything works fine now.
Thank you so much for your help.
Type: Posts; User: Momboz; Keyword(s):
I didn't do that setting before. I did it now and everything works fine now.
Thank you so much for your help.
Hi
I am trying to run a PIC18F14K22 in PLL mode with internal oscillator and PLL (i.e. frequency x 4). The internal clock should be 64'000'000 MHz. Here is my sample code:
asm
__CONFIG...
Dear DT
I would like, first, to thank you very very much for your support and then I wish to give you a feedback on how far I went with my SPI interface.
After some investigation I could find...
@falingtrea
Many thanks for the advice. I have seen these examples and I couldn't succeed since I need a peer to talk to via the SPI. I am intending just to drive a MAX7219.
Vielen Dank...
Sorry DT
I wasn't complete in my previous answer.
The first thing I did was to test with the addition of the while loop as you proposed and it wasn't successful, i.e. No toggle on PORTB.0...
Many thanks Darrel Taylor.
Yes, you are right that's a mistake I have made. I wanted to have SSPM3:0 = 0010, i.e. the lowest speed.
I am not that far, I will check this later on.
If I...
Hi Mister-e
Many thanks for the quick reaction.
As to the schematic nothing special but a PIC 16F876 with a 20 MHz crystal on a Mel PCB (PICPROTO-USB). I am checking with a scope (PCSU1000) the...
Hi guys
I have been looking around for a while (almost the whole day) to find an example on how to use the SPI interface on a PIC 16F876 and I couldn't succeed. It works fine with SHIFTOUT but I...
Hi
Here is an adaptation of Mister_E USBDemo but in Delphi. It's not completely finalised but it works. This example bases on the PICPROTO-USB board from MELabs (you can get all the information on...
Dear Steve
I would like to give you feedback on 3 points:
1st, there is a typing error in your example USBDemo.pbp source file. Line 39 in your file should say "_FCMEM_OFF_1H" and not...
Many thanks Steeve
I have copied all the files in the folder where I have PBP 2.47 installed and I tried to compile again. The errors are the same.
I have been surprised by the way you did...
Hi skimask.
First, many thanks for your help.
Second, I know from Melabs, that they support 2450/4450 in the USB modes.
My issue again is: I was not trying to use any other PIC, but 4550. I...
Dear all
I am a newbie who's tying to do his first steps with UBS programming under PIC. My environment is PBP 2.47, Microcode Studio 3.0.0.0 and MPASM 5.03.
I am using microsontroller PIC...