Setting Question for Hardware Serial Coms

Much of my serial coms is done via 56K baud which I think requires a 16bit baud rate generator of the PIC's EUSART baud rate generator to access accurately. To access that functionality of the EUSART I need to set the BRG16 bit within the Baud Rate Control Reg. So, my question is - does setting the Baud Rate under a DEFINE statement set that register bit or do I need to set it manually? I can't find any other DEFINEs that overtly set that particular bit.

Thanks,

Troy

BAUDCTL.3 = 1 ' Enable 16 bit baudrate generator

Thanks Dave. So it sounds like the answer is a manual setting. It would be nice to have this formally documented somewhere though.

Regards,

Troy