16f1847 hserout

Hello Folks -- going to (hopefully) use a 16F1847 with HSEROUT. Always have used the software SEROUT before so this is new territory.

To possibly save time, could someone tell me the commands to configure this chip for using the UART and HSEROUT at 9600 baud please. So much easier to just ask then spend all day searching.

BIG THANKS for any help.

Quote:

---

So much easier to just ask then spend all day searching

---

how are you off for socks and underpants ?

Do this:

On page 154 of the Pic Basic Reference Manual copy the DEFINES and test them to confirm that your circuit works as expected at 2400 baud.

I know it is not exactly what you want but after that giant leap I am sure you will be able to do next steps forward.

Ioannis

Thanks.
My ultimate goal is to interface a 16F1847 to a Raspberry PI 3B with RS485. The PI UART though needs 3.3v but I do see that the 16F1847 will work at 3.3V ? Can anyone verify that it performs reliably at that voltage?

3.3v seems to be working well so far. I breadboarded the pic feeding into the PI uart.

If the datasheet says it works on 3.3Volts there is no doubt that it will. Trust it.

Ioannis

100% 16f1847 work at 3,3v , I worked many time.

Fellas --

Is there any way to simply flip a byte so that MSB becomes LSB or vice versa?
Can't remember what the default is but I need to reverse it (or redo my *^% switches).

Thanks.

Code:

---

FOR i = 0 to 7
Correct.0[7-i] = Mistake.0[i]
NEXT

---

or

Code:

---

Correct = Mistake REV 8

---