Unable to program 18F67J94
Recent upgrade to PBP3 and it is running perfectly with another J-chip(18F26J53). Not so with the 18F67J94. Click program and get "Target device does't match.....)" Tried the usual things all OK. I Have R-checked all traces and all voltages are normal. This chip was mounted on a inline DIP breakout board. No currents above 15-20mA. observed. Is there anyone out there that can confirm that they have used PBP3 with this chip and have had no problems. I may have over looked something or have a couple of dead chips? Thanks.
Re: Unable to program 18F67J94
There's alot of things it could be.
Unlikely there's anything wrong with a new chip from Microchip or any of the big distributors.
Check pinout of chip against breakout board.
Put old chip back in and make sure nothing changed on board.
Re: Unable to program 18F67J94
The melabs website shows that PBP3 supports that chip. I have never seen a defective PIC in all the years I've programming them. More than likely that you are not setting the registers correctly. Check the settings again. The problem might be there.