Most memory saving way for comparing 98 preset values with ADC input?

Hello.

Have to run a code in 12F1840, so quite limited in memory.

What I have. There are 98 preset values, pre-defined at programming stage, will not change, ranging from 0 to 100. The code should measure ADC input, convert it to 0-100 range value, and generate HPWM with duty cycle according to one defined in table. Say ADC reading is 20, then data is read from 20th cell of table, and data is 45 in that table. And so on. PBP allows several ways to do this, like multiple if-then, arrays, etc. Which one will be most memory efficient?

On page 13 of the PIC12F1840 Data sheet, Section 3.1.1.1, the RETLW ASM command is explained. It's used on the following page as well. Finally, on page 299 the Instruction RETLW is covered.

Is this ASM discussion forum?

Try coding it as a huge SELECT statement, you might be surprised how little memory it uses.

Gentlemen... Does PBP provide a way to access Special Function Registers, like FSR0L, FSR0H, INDF0, etc., directly?

Quote:

---

Does PBP provide a way to access Special Function Registers, like FSR0L, FSR0H, INDF0, etc., directly?

---

yes there are a number of ways
my favourite is

timer0 var byte ext
@timer0 = TMR0

OR even

myFSR var word ext
@myFSR= FSR0L

or inline asm

@ FSR0L=22


OR USING PBP MACRO

PBPBYTE VAR BYTE
PBPWORD VAR WORD

@ MOVE?BB _PBPBYTE,FSR0L
@ MOVE?WW _PBPWORD,FSROL

surprised no one pulled me up on this

Quote:

---

or inline asm

@ FSR0L=22

---

should be

or inline asm

or just

FSR0L=22