I2C read and write to 24C01 eeprom

I and difficulty reading and write to the eeprom,the reading instruction I used is

I2Cread SDA,SCL,$A0,$00,[data1.......data7]
I2Cwrite SDA,SCL,$A0,$00,[data1......data7]

all data are define as word variable

I'm not sure it have written into the memory correctly or not,but the value of data1 can read into data3 and data2 value can read in data5

I have check with a oscilloscope using I2C analysis,trigger on missing acknowledge signal all data return no acknowledgement
have I did something wrong?

From the manual, p. 158:

Quote:

---

The Address size sent (byte or word) is determined by the size of the variable that is used. If a byte-sized variable is used for the Address, an 8-bit address is sent. If a word-sized variable is used, a 16-bit address is sent. Be sure to use the proper sized variable for the device you wish to communicate with. Constants should not be used for the Address as the size can vary dependent on the size of the constant. Also, expressions should not be used as they can cause an improper Address size to be sent.

---

If using bytes then the format would be something like

Code:

---

I2CWRITE SDApin,SCLpin,$A0,$00,[data1,data2,... etc etc]

---

If using word variables the format would be something like this

Code:

---

I2CWRITE SDApin,SCLpin,$A0,$00,[data1.lowbyte,data1.highbyte, data2.lowbyte,data2.highbyte, etc etc]

---

IC2READ would have the corresponding values in its statement

you don't say what chip/osc you are using , consider this

Quote:

---

The timing of the I2c

instructions is set so that standard speed devices(100kHz) will
be accessible at clock speeds up to 8MHz. Fast mode devices (400kHz) may be
used up to 20MHz. If it is desired to access a standard speed device at above
8MHz, the following DEFINE should be added to the program:
DEFINE I2C_SLOW 1

---

also read the data sheet for your eprom re
1. address command size
2 page size
writes that exceed a page in size or cross a page boundary can go wrong

read the manual and watch out for common myths

Richard, I was using the OP's example hence the address, and trying to explain that as a word variable he needed to write the high and low bytes. It was not meant as an optimised example...

I used the following to send word variable values to a PCA chip.. it might not be tight code, it may not be "as it should" in the eyes of more experienced programmers, or it may not follow convention in the manual... But it works

Code:

---

    pcaChannel = 1 
    i2cControl = $6 + 4*pcaChannel                             
    I2CWRITE SDApin,SCLpin,i2cWriteAddress,i2cControl,[0,0,CH2_PWM.lowbyte,CH2_PWM.highbyte]

---

Quote:

---

Originally Posted by Scampy

I used the following to send word variable values to a PCA chip..

---

making a special case where endianness needs to be managed.

the pca chip requires the data sent low byte first, i2cread/write natively send high byte first.


to do that for a eprom is just a typing exercise

Hi Richard,

I did a project a while ago which stored word values to a 24LC02 EEPROM.
The only way I could get it to work was to use the lowbyte and highbyte method that Scampy mentioned.

Can you show me a snippet of your code that will successfully write a word value to EEPROM?

Cheers
Barry
VK2XBP

no problem barry, this scans i2c bus reports valid addresses
and then reads and writes a mixed lot of word/byte vars

ps used a 24c08