I don't understand my mistake

hello everybody,

before format my PC, my code worked well and the compilator too
after I installed all my programs (same programs) on my fresh windows, I got a error that I don't understand why...

this is my code simplified :

Code:

---

#CONFIG
    CONFIG PLLSEL = PLL3X            ;3x clock multiplier
    CONFIG CFGPLLEN = ON      ;PLL Disabled (firmware controlled)
    CONFIG CPUDIV = NOCLKDIV            ;CPU uses system clock (no divide)
    CONFIG LS48MHZ = SYS48X8            ;System clock at 48 MHz, USB clock divider is set to 8
    CONFIG FOSC = INTOSCIO                      ;HS oscillator, high power 16MHz to 25MHz
    CONFIG PCLKEN = OFF          ;Primary oscillator enabled
    CONFIG FCMEN = OFF            ;Fail-Safe Clock Monitor disabled
    CONFIG IESO = OFF            ;Oscillator Switchover mode disabled
    CONFIG nPWRTEN = OFF            ;Power up timer enabled
    CONFIG BOREN = OFF            ;BOR controlled by firmware (SBOREN is enabled)
    CONFIG BORV = 285            ;BOR set to 1.9V nominal
    CONFIG nLPBOR = OFF            ;Low-Power Brown-out Reset disabled
    CONFIG WDTEN = ON            ;WDT enabled in hardware (SWDTEN ignored)
    CONFIG WDTPS = 512            ;1:512
    CONFIG CCP2MX = RC1            ;CCP2 input/output is multiplexed with RC1
    CONFIG PBADEN = OFF            ;PORTB<5:0> pins are configured as digital I/O on Reset
    CONFIG T3CMX = RC0            ;T3CKI function is on RC0
    CONFIG SDOMX = RB3            ;SDO function is on RB3
    CONFIG MCLRE = ON            ;MCLR pin enabled; RE3 input disabled
    CONFIG STVREN = ON            ;Stack full/underflow will cause Reset
    CONFIG LVP = OFF            ;Single-Supply ICSP disabled
    CONFIG XINST = OFF            ;Instruction set extension and Indexed Addressing mode disabled
#ENDCONFIG

DEFINE OSC          48

OSCCON  = %01110000    'OSCint = 16Mhz
OSCCON2 = %00010000
ACTCON  = %10010000

ProgramStart:
    clearwdt
    goto programstart

---

with this code, I got a config directive error

http://img4.hostingpics.net/pics/346529Sanstitre.jpg


and the error file :

http://img4.hostingpics.net/pics/934184Sanstitre.jpg

someboby can help me to resolve this error?

thanks

Hi,
CONFIG nPWRTEN = OFF
CONFIG nLPBOR = OFF

I don't the n's should be there. I don't have the config files on this computer but verify that 285 is indeed a valid setting for the brownout, message says it's not....

Are you compiling for the correct chip?

/Henrik.

hi,

this was my first idea, but the n's is correct, it is the same in pic18f45k50.pbpinc file
and the 285 value for BORV is correct too

may be I don't check an option in editor option? I really don't know because this code work well before format and install the computer...

hi,

I find my mistake :-)
I uninstall mplab 8.85 for the last mplab version : 8.92...

and now all my code is compiled without error ... really crazy :-)