Printable View
Hi all,
I am integrating a GPS receiver into one of my easypic4 development board Port. I want it to get the coordinates of the Northing and easting location of the receiver. How do I go about writing the codes to initialise the GPS receiver modules into the easypic4 port and get the northing and easting coordinates of the location?
Any help is appreciated. Thanks. =)
Which port ? who will decide port ?Quote:
Originally Posted by supertyx
which GPS receiver ?
where you wants to diplay coordinates after received ?
are you want whole code? or wirtten something ?
.
Which port? RS232? PS/2? SD card? Power? Programming? Port of Entry?Quote:
Originally Posted by supertyx
Practice...practice...practice...Quote:
How do I go about writing the codes to initialise the GPS receiver modules into the easypic4 port and get the northing and easting coordinates of the location?
Quote:
Originally Posted by precision
The GPS module i'm using is a 32 Channel 5Hz GPS Receiver with MCX Jack.
This is the link containing the information about it :
http://www.sgbotic.com/index.php?tar...&product_id=34
I want to display the coordinates on the LCD display on the easypic4 development board.
Any help on the codings would be appreciated.
Thank you.
This thread is a good start.
http://www.picbasic.co.uk/forum/show...t=16f88+device
You will have to find how to get your module to output NMEA data. The coordinates are in the $GPGGA, $GPGLL or $GPVTG words. You can communicate with most GPS using Serial communication.
See how you go.
Mike