This project requires a 100k device and a 400k device on the same bus.
The I2C slow command appears to be compile only.
Is there a way to change fast to slow and back again at runtime?
Thanks.
Printable View
This project requires a 100k device and a 400k device on the same bus.
The I2C slow command appears to be compile only.
Is there a way to change fast to slow and back again at runtime?
Thanks.
No. But as far as I know all 400K devices work on 100K.
If you need the speed, then what devices are running at 100K?
or use the mssp module if your chip has one
http://support.melabs.com/forum/picb...c-hardware-i2c