I agree 100%. The U2 USB Programmer makes your life a lot easier. I have been using it for years without any issues.
Hi. Is this a PBP3 DEFINE? I don't see this in my PBP 2.60 manual. What does it do?
The Melabs usb programmer program has a pull down menu for options.
Un-check the "Update configuration from file". Now it will keep the configurations
you selected and not reset these...
@ Peter - you didn't say which programmer you are using, but mine resets the bits to a default and needs to be changed every time. I guess they can behave differently. (Granted mine is a clone).
Hi everyone, I read that PIC can be interface with thermal printer with RS232(interface)...but to make sure can anyone suggest where (link) I can get one? And do all printer(thermal printer with...
swr999, I have used the "DEFINE WRITE_INT 1" directive with my 18F parts and have had no problems. The READ instructions are not to my knowlege prone to disruption with interrupts enabled.
it works for me pbp3 pic16f1825 // ds1307 // pcf8574a either your code is wrong or your not connecting things properly
tested at 8mz an 32mhz the pcf8574a has no problem
have you seen this ?
Umm, no, you only have to alter the dropdown contents if you need to change anything.
Before the programming starts, the existing config is read and doesn't change unless you tell it to. So makes...
I'm going to try this. Thanks!
Also, does the same apply to EEPROM reads? I assume a READ instruction can get messed up if the interrupt occurs at just the right time during the READ?