I'm no expert on schematics, but something doesn't sit right with the coms section. The 5v logic is used to turn on the 2n3906 via a 4k7 current limiting resistor. To...
This is the section that I use in all my programs that use a 4 x 20 LCD
DEFINE LCD_DREG PORTB ' LCD Data port
DEFINE LCD_DBIT 0 ' starting Data bit (0 or 4)
Guys, just wanted to do a big shout out for TabSoft for producing a new include file for the AM2302 (and similar) range of humidity / temp sensors.
I'm in the process of upgrading the...
The "Using Scaler Variables" section in the PBP manual describes this.
You can do this:
T1Val = $FC7C
T1Val = T1Val + 1 ' $FC7D
TMR1L = T1Val.BYTE0 ' $7D
So I can write: T1Val=T1Val+1 resulting in T1Val incrementing from FC7C to FC7D?
At 8x8 resolution, as you get away from even 90 deg angles, it looks horrible.
I agree with both of these sets of suggestions.
Not only is the word "DEFINE" required to be UPPERCASE but currently ALL internal PBP define "Parameters" need to be uppercase as well. The...
as a first attempt ... always place some pause ( 500 ms or + ) @ powering up the LCD ...
and do not tick the "case sensitive" box ...
Now, MCS is V 184.108.40.206 ... MPLAB is V 8.92 ... MPASM...
I also found this code written by norohs difficult to work out and eventually I decided that it works more by accident than design and that there has to be a better way of doing this. This is what I...
you might get something from this
or tell us more on what your trying to achieve and post your code (in code tags)