My name is Stella and I am from London,UK,I have recently buy a printer and It was functioning well ,But unexpectedly it stops working and screening some text error message in the...
Maxim has an application note for searching serial numbers of unknown devices. Please see the attached pdf file. It includes the algo and C code (sorry no PBP code yet).
Hope this helps,
just bought a second-hand SUV-Toyota RAV4,preparing a exciting drive traveling,unfortunitly,the initial installed gps was broken,so i prepare install a new one by myself,anyone suggest some suitable...
OK ART ,
please see attached - code 2 is portE.4 working - see hex
code 3 port F.0 not working - see hex
nice post,as a new here,ive learned much!
That's not quite what I meant.
I mean only the code required to test the two pins, very minimal.
It can be seen from the hex disassembly if the bank switching is happening or not.
It only makes...
I've never used USB (tried once, couldn't get it to work) but here's my interpretation of the figure in the previous post.
If you connect a 4MHz x-tal to the PIC you need to set the...
ok , the results of adding the nops , did not have an effect on the working ( port E) or the not working port ( port F)
values writen to eeprom were only for port e , all pins on port E have a...
i dont want to do reverse.
i looking for how to write new software with pbp as the assembly.
i dont undestand assembly that is my problem.
i offer that job to who know assembly.
Whatever your minimal config and setup for PULSIN on two ports here,
and make a pin that DOES work and a pin that DOES NOT work an input
if PBP requires it for PULSIN.