Symbols in PBP have meaning that may be different than other languages, I. E. "C" .
% is used for binary, example %11111111 it does NOT use 0b00000000 or $00000000 as binary
$ is used for HEX ,...
Could be RMW issue if those T# are on same port, better in that case to change them all at once like PortB=%00000100 PortB = %00000011
This is a duplicate thread! There are answers on your original thread.
t2 is the timed pin?
is tflag being reset to 0 elsewhere in your code?
Like you I see no problem with this snippet.
This is a HPWM pin?
Why not use HPWM you must have your reasons I guess.
Hello every body: I just joint the forum. Switching now slowly over from Basic Stamp 2 to the pick micro. I have Basic pro Gold . I have programmed some 12f683 successful. However I started now...
Hi guys ,
i am trying the get PWM (CCP4) output to work on PortG.3 of the 18F67k22 series
what i am seeing so far is that the port seems to put out some pulses then stops , so it seems that i...
Start by adding a PAUSE 500 after you turn the LEDs on and off.
Your LED is probably blinking faster than your eye can detect (or not leaving enough time for the LED to emit light).
While all are better than what I was playing with, I like the array scheme. I just don't do enough arrays to keep them front and center in my head.
Unfortunately, I didn't have the...
[/CODE]This the way to display you code