Hello, welcome to our forum.

It looks like you have registered but you have not yet posted and messages. Our requirements are that you must post at least two messages, to allow the moderators to review your registration, before you will be allowed access to the full range of forum areas.

Please make a couple of posts, until then you may see a notice that says you are banned from certain forum areas.

Thank you.

• ### Recent Forum Posts

#### View Post

have here a full FreindlyArm SDK I have TWO of these in New unused working order, complete with WiFi modules cables, SDK on DVD

Offers over £30 (for 1 SDK ) exclusive of VAT & postage and...

lester Today, 11:59

#### How to build FM transmitter?

Hello,
I want to build a FM transmiter ?
how should start it calculation?

in general discussion

RITESH Today, 09:47

#### Re: Button sequence

TRISB = %11111111 ' PortB is input for starters.
PortB = %00001110 ' PortB.1-3 high

Switch VAR BYTE
...

HenrikOlsson Today, 09:34

#### Re: Button sequence

Hi Dave,
Quite right, thanks for catching that. Need to give this some more thought.

/Henrik.

HenrikOlsson Yesterday, 15:13

#### Re: Button sequence

Henrik, I think your logic is incorrect. Assuming all pins B1,B2,B3 have appropriate pull down resistors, how it the statement sequence:

TRISB.1 = 0 ' Drive B1 with high state
S2 =...

Dave Yesterday, 13:16

#### Re: how to write ABCD on four seven segment display

Really easy with help of 4 x 74AHCT595:
8359

harryweb Yesterday, 13:13

#### Non Volatile JK Flip Flop

Hi Guys :)
Here is a little project using a pair of square loop ferrite cores to store 1 bit of data without power.
Typically, you could write to it by turning the circuit on, setting the state,...

Art Yesterday, 11:08

#### Finding the least common multiple, LCM of three numbers

I have a situation in PBP where I need to calculate the LCM of three numbers, each of which are never larger than 16. Can anyone point me to a simple method for calculating these please?

whoop_john Yesterday, 09:18

#### Re: blink a single led

HELLO rICHARD,

the code displayed there is for timer, interrupt, and digital conversion.
that run well for several years.
...

MINHLE - 7th December 2016, 11:32

#### Re: how to write ABCD on four seven segment display

Well post up the code you have, with details of the PIC and the circuit drawing and I'm sure someone will offer suggestions

Scampy - 7th December 2016, 10:22
• ## ozarkshermit

### 5x5x5 Red-Green LED Cube

by Published on - 4th February 2011 19:54  Number of Views: 5999

I wanted to build a LED Cube for some time, just for fun, and started with a small 3 x 3 x 3 using someone elses downloaded ...