Tumbleweed, I had very strong suspicions that the issues were in the communication lines. I changed the Baud rate from 19200 to 9600 and I haven't got anymore wrong data at the receiver. I remember...
Ioannis, yes I'm doing data validation checks all the time. The first byte of the array is always 174. If this condition is not met, then the reading is discarded.
There is no much code to show here. I know device A is sending the right data because I can see it with a logical analyzer. I know device B, like 1 out of 5 times, is reading some bytes wrong because...
I tried removing the 10k resistor and I'm still having the same problem. The PICs are in two different PCB boards. The serial communication is taking place over a 3ft cable. The cable has 2.5mm mono...
Another thing that could be causing problems is that SEROUT2/SERIN2 are software bit-banged (no hdw UART involved),
so device B must be sitting waiting at the SERIN2 for the first start bit before...
Competitions are subject to the privacy policy and website terms and conditions of picbasic.co.uk, owned and controlled by Crownhill Associates Limited (“Crownhill”).
The following rules shall apply, together with any instructions or rules specific to any current competition. By entering any of the community run competitions, you are deemed to have accepted the following:
...
Common Development and Distribution License (CDDL) is a free software license, produced by Sun Microsystems, based on the Mozilla Public License (MPL), version 1.1.
Re: SERIN2 Receiving Wrong Data
Tumbleweed, I had very strong suspicions that the issues were in the communication lines. I changed the Baud rate from 19200 to 9600 and I haven't got anymore wrong data at the receiver. I remember...
rsocor01 Yesterday, 22:35