Do you think it would be too risky to just assume the transmission is complete if I am only sending a byte or two?
just send using MSSP and go about your business or must I poll the flag?
do I have...
Correct on both accounts. As the SPI clock frequency goes up there's not much gain going the interrupt route so you can just as well poll the flag like that. The MSSP module CAN be a bit tricky to...
Hi,
If you have WORD sized variable and specify 12bits, MSBFIRST, one might think that it would shift out bits 15-4 but it doesn't. It shifts out bits 11-0. With LSB first it shifts out bits 0-11. ...
SHIFTOUT is a software-based command and does not require that the target device have synchronous serial capability. The ClockPin and DataPin parameters...
Competitions are subject to the privacy policy and website terms and conditions of picbasic.co.uk, owned and controlled by Crownhill Associates Limited (“Crownhill”).
The following rules shall apply, together with any instructions or rules specific to any current competition. By entering any of the community run competitions, you are deemed to have accepted the following:
...
Common Development and Distribution License (CDDL) is a free software license, produced by Sun Microsystems, based on the Mozilla Public License (MPL), version 1.1.
Re: Shiftout question about the manual statement
Do you think it would be too risky to just assume the transmission is complete if I am only sending a byte or two?
dsicon Today, 00:25just send using MSSP and go about your business or must I poll the flag?
do I have...