It looks like you have registered but you have not yet posted and
messages. Our requirements are that you must post at least two
messages, to allow the moderators to review your registration, before
you will be allowed access to the full range of forum areas.
Please make a couple of posts, until then you may see a notice that
says you are banned from certain forum areas.
As I said , I'll design the PCB according to the technical specs of all these ICs so measuring it will be possible only when the PCBs arrive .. But so far you've been very helpful to all my questions...
It might, if it was allowed to but it can't since the output can only source 2mA. If you're worried, why not measure it? Add an external series resistor if you want to be sure that the circuit can't...