I know. It's a real shame that we lost him.
goodo not the most elegant solution modifying dt ints like that, i'm sure dt would have found a way to identify that chip for a conditional compile to keep things nice
I had a similar problem before. See the thread below, http://www.picbasic.co.uk/forum/showthread.php?t=22447&p=140029#post140029
It works!!!!! Thanks a million. :rolleyes:
back in an hour, just replacing my disappointing led [40w replacement fluro tubes] with some nice 24w daylight led ceiling fittings in the workshop
try this DEFINE OSC 32 'Define Oscillator to 32 MHz OSCFRQ = %00000110 'DEFINE OSCFRQ TO 32 MHZ LED1 VAR PORTB.1
Here is the code just to test it, DEFINE OSC 32 'Define Oscillator to 32 MHz OSCFRQ = %00000110 'DEFINE OSCFRQ TO 32 MHZ LED1 VAR PORTB.1 ...
i don't see any INT_ENABLE T1_197_INT Post the code, I don't have one of those chips and can't compile for it either still on 3.0xxx
Hmm, it compiled okay, but it didn't work.
try adding this interrupt definition to the dt_ints-14.bas at the top of the definitions #define T1_197_INT PIR4,TMR1IF, PIE4,TMR1IE ;-- TMR1 - 16f19197 * then rename your interrupt...
There is no content in this section
Menu
Re: DT Interrupts not Working with PIC16F19197
I know. It's a real shame that we lost him.
rsocor01 Yesterday, 15:18