Hello, welcome to our forum.

It looks like you have registered but you have not yet posted and messages. Our requirements are that you must post at least two messages, to allow the moderators to review your registration, before you will be allowed access to the full range of forum areas.

Please make a couple of posts, until then you may see a notice that says you are banned from certain forum areas.


Thank you.
  • Features



    PICBASIC PRO™ Compiler 3.0
    • Familiar BASIC syntax
      • IF (condition) THEN / ELSE / ELSEIF /ENDIF
      • SELECT CASE
      • FOR… NEXT
      • DO WHILE/UNTIL
    • Direct Register Access
      • All Special Function Registers are pre-mapped by PBP and accessible by name
    • Built-In Commands for operations common to embedded development
      • Accurate Delays in uS and mS resolutions
      • Analog to Digital Conversion
      • Asynchronous Serial Communications (RS-232, RS-485, etc)
      • Synchronous Serial including I2C and SPI
      • Character LCD
      • PWM
      • USB
      • Parsing and Formatting of ASCII Strings
      • Sinusoidal Frequency Generation and DTMF (requires hardware filtering)
      • Pulse-Width Measurement
      • Low-Power Mode
    • Conditional Compilation with Command-Line Constants
    • In-Line Assembly Language
    • Easy Device Configuration
      • Configuration settings listed for each supported device
      • New #CONFIG directive eliminates the need to edit header files
    • Interrupts in BASIC or Assembly Language
    • Newly revised and expanded, 300+ page reference manual.
    • MPLAB/MPLABX compatible.
    • Technical Support via Telephone, Email, and Community Forum (phone and email support not available for Experimenter Edition.)