I assume you are correct, thanks but I really think that could be worded much more clearly if so.
The manual says SHIFTOUT is about 50kHz clock dependent on osc freq, what is 50k based on osc...
Hi All
Thanks for all your advice guys.... Turns out I was right with the defines except the 9600 should have been 9615
The thing that fixed it all was putting a small delay (pause 100) between...
Hi,
If you have WORD sized variable and specify 12bits, MSBFIRST, one might think that it would shift out bits 15-4 but it doesn't. It shifts out bits 11-0. With LSB first it shifts out bits 0-11. ...
In the PBP3 manual there is this paragraph:
SHIFTOUT is a software-based command and does not require that the target device have synchronous serial capability. The ClockPin and DataPin parameters...
Probably yes. But it depends on how you write code.
Looks great!
BAUDCON does not appear in 628 or 628a data sheet.
MisterE Multicalc shows
Registers
RCSTA = $90 ' Enable serial port & continuous receive
TXSTA = $24 ' Enable transmit, BRGH = 1
SPBRG =...
Since I've almost finished development of this clock, including hardware side, and I want to post an instructable, I want to make my code a bit tidy also. I have made several screen update routines,...
CuriousOne Yesterday, 19:26
Re: Shiftout question about the manual statement
Correct on both accounts. As the SPI clock frequency goes up there's not much gain going the interrupt route so you can just as well poll the flag like that. The MSSP module CAN be a bit tricky to...
HenrikOlsson Today, 20:41