First post your code here...
Clkout is FOSC/4, so OSC is set to 8MHz, you should get 2MHz on pin.
I have been testing a program for a 12F683 to drive an RC servo. The compiler is Picbasic Pro ver 3 and both QL 200 and IDE 2 programmers give the same result. The programmed chip does nothing. ...MillicentBear Today, 02:03
For the #1, I've read 16F1829 datasheet, and it says that it can emulate 555 timer in hardware, so I guess, it might be possible to do what I want.
For the #2, I see this In the...
1) For a short answer I would say no, not really but a standard timer interrupt can easily be used (which then obviously uses a combination of hardware (the timer) and software (the interrupt service...HenrikOlsson - 19th February 2017, 11:39
Two more interrupt/timer/pwm questions, if you don't mind.
1. Is it possible to configure timer to enable-disable hpwm generator at predefined time amounts? say, 1 second on, 1 second off. So all...
Are talking about re-attaching tables? Don't bother your users with that. I can show you how to do it programmatically. FYI, if you own Office Developper edition you can distribute the Access Runtime...MichelJasmin - 17th February 2017, 18:19
If the application allows you can disable interrupts while
those commands are running, and re-Enable straight after.
No good for some applications such as a real time counter
but in others you...