It looks like you have registered but you have not yet posted and
messages. Our requirements are that you must post at least two
messages, to allow the moderators to review your registration, before
you will be allowed access to the full range of forum areas.
Please make a couple of posts, until then you may see a notice that
says you are banned from certain forum areas.
I am trying to send you a private message, but I keep getting logged off each time I attempt to. Could you send me a private message so that I can see if reply works? Thanks,
I am having problems posting private messages. I keep getting logged off with every attempt. I thought I would try a forum message to see if I have the same problem.
Frequency is controlled by the scaler in T2CON and the value of PR2. The setting I'm using provides for the slowest frequency possible with my OSC speed; PR2 = $FF. The reason I do this the long...
Hi Mike,
Thanks for your help, I need to use directly from PBP, I have an older version.
I'm thinking of using a single PWM PIC like PIC18F1320 to control two analogue values then use sample and...
You can use the HPWM command or you can manually control the PWM function. In the Data Sheet in the CCP section, PWM subsection, the ASM code is listed for firing up TMR2, activating the PWM, then...
Hi,
I have 18F2320 has anyone used HPWM on this PIC? I have EPIC programmer is ok to program this chip?
I looks it has 16 bit PWM can I use it for 8 bit only? has anyone used both pwm's since it...
Again my biggest thanks. I will play with it as time permits. Yes I had looked at the BOB4 sometime ago and it was only white from what I remember.
Eagle Tree (...
Menu
Re: Help converting small PicBasic program to MP LAB
Oh, I'm getting them Jim, all of them (I think) :-)
HenrikOlsson Yesterday, 19:58/Henrik.