By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
That's probably what's helping a lot more than any line noise issue.
...
Tumbleweed, I had very strong suspicions that the issues were in the communication lines. I changed the Baud rate from 19200 to 9600 and I haven't got anymore wrong data at the receiver. I remember...
Ioannis, yes I'm doing data validation checks all the time. The first byte of the array is always 174. If this condition is not met, then the reading is discarded.
There is no much code to show here. I know device A is sending the right data because I can see it with a logical analyzer. I know device B, like 1 out of 5 times, is reading some bytes wrong because...
I tried removing the 10k resistor and I'm still having the same problem. The PICs are in two different PCB boards. The serial communication is taking place over a 3ft cable. The cable has 2.5mm mono...
Published on - 5th December 2010 16:58
Number of Views: 7577
Hi,
Here's a short list of Frequently Asked Questions that should be of interest for most beginners. Don't hesitate to read them... they're not going to bite you
Re: SERIN2 Receiving Wrong Data
By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
tumbleweed Today, 12:26That's probably what's helping a lot more than any line noise issue.
...