you have set timer1 to overflow every 16.38 mS , you never count the overflows
also adding 65535 to a word var seems very odd do you actually intend to subtract 1
Thanks for reply !
T1CON = %00000110 ; this command does not start timer1?
Or do I have to use the command: T1CON.0 = 1 'start Timer1 ?
How to see if button is released ? IF DataW.... it's...
in order to measure a buttons hold time you need to either note time button was pressed then the time button was released
the duration is release time - when pressed time, or when button is...
Howdy ! I'm back on the forum after some absence (I had some personal problems).
I am trying to develop a project. I use a PIC12F675 with which I read the value of a group of 6 resistors, of...
Published on - 5th December 2010 17:58
Number of Views: 7413
Hi,
Here's a short list of Frequently Asked Questions that should be of interest for most beginners. Don't hesitate to read them... they're not going to bite you
Re: How to measure how long I pressed a button ?
i possibly could be enough but you never reevaluate it until the whole timing mess has long completed
richard Today, 10:49