I don't really use serin so I can't be of much help, but just to educate me: isn't the contents inside the square brackets a qualifier or filter - like the WAIT modifier in serin2?
Thanks for the reply. Yes, ProgIDRx is cleared. And its value is $A (or10). But, I haven't been able to receive it yet because nothing is being received. SERIN always exits upon the 5...
two thoughts looking at your code.........
...ProgIDRx = $A............ did you CLEAR ProgIDRx after reception and might need to be ....$"A" not sure but
I have a very simple task to perform. I need to pass a couple of bytes from one PIC12F683 to another PIC12F683 and can't get it to work! I've tried everything that I could think of and...
Published on - 31st May 2010 17:24
Number of Views: 5644
Since this question has come up again, I thought I'd throw this module out to the masses. It is something I worked on a while back, with DT's help. Amid life's other priorities, it got put on the shelf to collect dust.
The basic idea is that by adding the module as an INCLUDE and inserting a couple of commands inside your code, you can have the PIC send timing data to your PC via the hardware serial port. It's made for 18F PICs (although some 16Fs may work too). You also need a timer that is not being used for anything else.
1) Instructions are included, as well as a small example.
2) It worked well for me, and as I recall, DT in testing.
3) Use it however you want.
4) I won't be able to offer much support, but figure there are enough knowledgeable folks around here that can help those who need it.
Re: Serin Not Recognizing Qualifier From Another PIC
I don't really use serin so I can't be of much help, but just to educate me: isn't the contents inside the square brackets a qualifier or filter - like the WAIT modifier in serin2?
rocket_troy Today, 03:24Troy