MEL PICBASIC Forum - Add New Section

• ### Recent Forum Posts

#### Re: Watchdog timer not working as expected

This is not correct. The original code is fine.

The keyword DEFINE is a PBP keyword so it's NOT case sensitive, can be define, DEFINE, DeFiNE, DEFine, however you want to write it. The thing that...

HenrikOlsson Today, 08:54

#### Re: Newbie Manchester Coding question

Looks straight forward, esp if you use a chip with gate control and can set a timer to count in 1uS increments

what did you have in mind ?

richard Today, 08:05

#### Re: Watchdog timer not working as expected

From the PB3 manual

2.15 Case Sensitivity
PBP is not case sensitive, but Assembly Language is. This means that there are
situations where case matters

2.15.1 DEFINEs
Since many of the...

aerostar Today, 06:30

#### Re: Newbie Manchester Coding question

Apologies, I was beginning to think nobody was responding so it's been couple of days since I've checked.

They're old temperature sensors I picked up cheap and I was hoping to utilise for a...

rocket_troy Today, 06:08

#### Re: Complex math on 16F series?

Check this one first:

and then check this one second:
http://dt.picbasic.co.uk/CODEX/N-BitMath

or reverse the order.

sayzer Yesterday, 22:10

#### Complex math on 16F series?

d = 1 / ((x1 - x2) * (x1 - x3) * (x2 - x3));
a = d * (x1 * (y3 - y2) + x2 * (y1 - y3) + x3 * (y2 - y1));
b = d * (x1 * x1 * (y2 - y3) + x2 * x2 * (y3 - y1) + x3 * x3 * (y1 - y2));
c = d * (x1 * x2...

CuriousOne Yesterday, 21:17

#### Re: Help with Using the Catalex MP3 Player

Nice one Brek! Forgot there was that second switch.

Ioannis

Ioannis Yesterday, 19:44

#### Re: Help with Using the Catalex MP3 Player

There’s another switch contact on the rotary dial to tell you the dial is in the home position doing nothing.
The dial switch does nothing while the dial is being rotated clockwise by the finger so...

Art Yesterday, 17:43

#### Re: Watchdog timer not working as expected

If you haven’t tied your MCLR pin high or disabled it, you could get an MCLR reset any time.
Same with a brownout reset. I haven’t checked this hex configuration values you gave (nobody is going to...

Art Yesterday, 17:33

#### Re: Si4702 FM Radio chip

My code in here is probably more sensible for PBP. In code examples is dirty to get most out of 16F628a.

Up to you, but that DT code link above is an otherwise lost original I think (which I...

Art Yesterday, 17:06
• # R/C

### Driving up to 9 servos with 2 I/O lines

by Published on - 23rd December 2010 14:25  Number of Views: 5328

This little code example demonstrate how to drive 9 servos using only two I/O lines. The PWM signal is then demultiplexed ...

### 2-CH Hardware Servo Driver

by Published on - 28th October 2010 13:57  Number of Views: 3827

Here's a 2 channel Hardware Servo Driver, that uses Timer1 and both CCP modules in Compare mode.
With an 18F.
...

### PWM : Servo PWM encode/decode

Number of Views: 6775

This project uses DT Interrupts to measure pulses being sent from your RC receiver, and also to create new pulses to be ...