From £49.95 |
Buy it Now LAB-X1 Bare PCB only* (With surface-mount oscillator multiplier attached, diskette and schematic.) |
Hi Troy,
Yes, the bracketed variable is the qualifier. SERIN won't receive or pass the data until it recognizes the presence of the qualifier in the received packet. For some reason, my qualifier...
one easy thing to do to troubleshoot your system....... add a temporary serout for the receiving 283 to see receptions and get all that working first as you continue with the rest of your code.... (I...
amgen Today, 14:28I don't really use serin so I can't be of much help, but just to educate me: isn't the contents inside the square brackets a qualifier or filter - like the WAIT modifier in serin2?
Troy
Hi Amgen,
Thanks for the reply. Yes, ProgIDRx is cleared. And its value is $A (or10). But, I haven't been able to receive it yet because nothing is being received. SERIN always exits upon the 5...
two thoughts looking at your code.........
...ProgIDRx = $A............ did you CLEAR ProgIDRx after reception and might need to be ....$"A" not sure but
Thank you Henrik for you prompt reply.
The Receiver PIC's GPIO.5 is indeed configured as an input and the two systems do share a common ground.
Transmit PIC - GPIO.2 is set as an output and...
Hi,
I have not looked closely at your code yet and I don't know if this will make any difference but I did react to the following:
Please note that the WPU is turned off when pin is configures as...
Hi Experts,
I have a very simple task to perform. I need to pass a couple of bytes from one PIC12F683 to another PIC12F683 and can't get it to work! I've tried everything that I could think of and...
JLCPCB: created my ZIP on April 10th, received today on April 16th via DHL courrier.
Demon - 16th April 2024, 14:49From £49.95 |
Buy it Now LAB-X1 Bare PCB only* (With surface-mount oscillator multiplier attached, diskette and schematic.) |
Re: Serin Not Recognizing Qualifier From Another PIC
Thanks Amgen. Good advice!
JESmitter Today, 16:52