From £14.95 |
Buy it Now For the 28-pin PIC® 14C000. |
- 12-bit ADC2
- 4/4 Timers
- 4 CCP & 2 PWM
- EEPROM
- 20-bit NCO
- PPS
- 4 CLC
I've used it in a couple projects. In one, I needed many PWMs but with PPS where I could swap output pins. In...
Well, what is it on that chip that is special?
You are brave enough to tame that beast called MPLABX!
Ioannis
Sheldon, lately I've been using XC8 in MPLABX. I fell madly in love with the PIC16F18426 and have used it for a couple projects. Because it was so new that PBP3 didn't yet cover it, I forced myself...
mpgmike Today, 16:54hi mike ,
has there any further updates to the int-18-k40 v3.4c
regards
Sheldon
NO! Don't hit the off switch. If it comes to that, ask for donations and count me in.
peterdeco1 - 4th December 2019, 20:08For this to work I think you need to have one-to-one project-workspace enabled (MPLAB main menu Configure | Settings... | Projects | Use one-to-one project-workspace model).
It's of limited use...
Your right. Did not see this. I'll let Lester know about it. Hope he can restore the missing posts.
Ioannis
Indeed, I've used such approach on Spectrum a lot :) we don't had "Enable V-Sync" feature these days..... :D
CuriousOne - 4th December 2019, 05:50
Re: IOC on the 27k40
Very nice!
Ioannis Today, 21:37Recently I was testing the 16F19176 chip. It has almost all of what you referred except NCO and is also supported by PBP.
I tried many times to take the leap to C but things stopped...